/*
 Please install the < Adafruit BMP280 Library > （https://github.com/adafruit/Adafruit_BMP280_Library）
                    < Adafruit SHT31 Library > （https://github.com/adafruit/Adafruit_SHT31）
 from the library manager before use.
 This code will display the temperature, humidity and air pressure information on the screen
 https://lang-ship.com/blog/work/m5stack-env-ii-unit-u001-b/
*/
#include <M5Unified.h>
#include <Adafruit_BMP280.h>
#include <Adafruit_SHT31.h>
Adafruit_SHT31 sht3x = Adafruit_SHT31(&Wire);
Adafruit_BMP280 bme = Adafruit_BMP280(&Wire);
float tmp = 0.0;
float hum = 0.0;
float pressure = 0.0;
void setup() {
  auto cfg = M5.config();
  cfg.serial_baudrate = 115200; // ボーレートを115200に設定
  M5.begin(cfg);
  M5.Display.setRotation(3);
  M5.Display.setTextSize(3);
  Wire.begin(32, 33);
  Serial.println(F("ENV Unit(SHT30 and BMP280) test..."));
  while (!bme.begin(0x76)) {
    Serial.println("Could not find a valid BMP280 sensor, check wiring!");
    M5.Display.println("Could not find a valid BMP280 sensor, check wiring!");
  }
  while (!sht3x.begin(0x44)) {
    Serial.println("Could not find a valid SHT3X sensor, check wiring!");
    M5.Display.println("Could not find a valid SHT3X sensor, check wiring!");
  }
  M5.Display.fillScreen(BLACK);
  M5.Display.println("ENV Unit test...");
}
void loop() {
  pressure = bme.readPressure();
  tmp = sht3x.readTemperature();
  hum = sht3x.readHumidity();
  Serial.printf("Temperature: %2.2f*C  Humidity: %0.2f%%  Pressure: %0.2fhPa\r\n", tmp, hum, pressure / 100);
  M5.Display.setCursor(0, 25);
  M5.Display.setTextColor(WHITE, BLACK);
  M5.Display.printf("Temp:%2.2f*C\n", tmp);
  M5.Display.printf("Humi:%2.2f%%\n", hum);
  M5.Display.printf("Prs :%2.0fhPa\n", pressure / 100);
  delay(1000);
}